Oval midget front bonnet

Original Midgets have contiguous kingpins through their uprights a. Collection within 10 days of auction ending less than 5 must contact me first before bidding welcome to view with arrangement. RFR Fuel pump breather in boot floor. Modified Flexi Form fiberglass leaf springs. The inboard ends of these supplemental links are attached to bosses on the roll cage. Other than that bit stiff but would free up with some wd That's a ways off, as I'm neck-deep in EFI and will then rebuild the engine to mount an M45 Eaton blower, and that's when I want the dam.

Fit an HIF44 - you will be glad of the extra 20mm! The flange is double thickness being a spot welded seam between the bonnet skin and the edge reinforcing and I doubt that hammering would work. I need to find a 4 tab and 4 bolt for a Oval. Clearly not something you would want to do with a nicely painted bonnet! This thread is from the archive. And after years of use it adds some extra curvature to the bonnet.

Wed Dec 23, 1: It also wobbles about a bit at speed. Easy does it as on such a shallow curve little stretching should be required to correct the problem. September 15, Posts: